TIME Electronics 7016 LPR Pressure Calibrator Single with Regulator

Price:

82.500.000,-

Quantity Order:

The 7016 can be used with the 7090 pneumatic hand pump ( -950 mbar to 40 bar) . Alternatively, the 7016 can be supplied without the internal regulator for hydraulic or pneumatic use up to 600bar - see separate 7010 Single channel and 7015 Dual channel datasheets.

For process signal calibration the loop signal is displayed on the LCD display to 0.05% accuracy. Loop drive supply ( 24V or 36V) is also provided. Both pressure and loop signal can be displayed at the same time to speed up the calibration of pressure transmitters. Additionally a continuity function is available for testing for open circuit loops.

The 7016 allows switch selection of five pressure units. These should be specified on ordering from the following: - bar, PSI, kPa, MPa, inWg, cmWg, inHg, mmHg, Kg/ cm2, atm. Both pressure and loop current are displayed on 4.5 digit LCD displays.

RS232 connection for display read-back when used with Time Electronics EasyCal calibration software ( option) . Straightforward calibration procedures are easy for the user to write within EasyCal. Results from procedures are stored in EasyCal� s results database and printing calibration certificates on demand is simple.

Power is via internal rechargeable cells with a built in mains charger. This allows the unit to be powered directly from the mains if required. The 7015 is housed in a strong resin case that provides on-site protection. All pressure connections are on the side of the case. Leads and an assortment of pressure connection accessories are provided.

For process control signal simulation Time Electronics� handheld 7006 Loop-Mate is available as an option. It provides 4 - 20mA and 0 - 10V signals at levels of 0% , 10% , 25% , 50% , 75% , 90% , 100% . It can also step through these set points automatically to allow hands free calibration. It is battery powered and can be stored in the 7016� s pouch. See separate data sheet.

Features:

Regulated Low Pressure
Accuracy 0.04% FS
Range options from 0.2 to 20 bar
Pneumatic
Over-pressure Alarm
Piezo - resistive pressure sensor
Isolated 24/ 36V loop supply
Loop current measure
Mains / Battery Power

Model 7016 : Pressure Calibrator Single with regulator ( vac, 0.2, 2, 5, 10, 20 bar)

Recommend to your friends majumapanmandiri@yahoo.co.id